This article explains how to upload a restore point to a connected ESXi host with VMware.
- Datto SIRIS
- Use this option if you want to use the ESXi host for computing power and as a datastore.
- Depending on the size of the datastore, this may take a while to transfer.
- once it transfers, there is no disk I/O burden on the SIRIS, or need for adequate bandwidth between the SIRIS and the ESXi host.
- The datastore is thick provisioned on the ESXi host, which increases the speed of the virtualization.
- This option is available for Windows and Linux protected machines.
- ESX upload for ReFS is currently unsupported. Any ReFS volumes in the selected snapshot will be excluded from the restore. To perform a restore of an ReFS volume, use the Volume Restore feature.
- Before proceeding, make sure a hypervisor connection is configured.
- If you're configuring a Standalone Hypervisor Connection, you will be prompted in the Connection Setup Wizard to select an offload method (NFS or iSCSI), as well as which of your SIRIS's network interfaces you'd like to use. Please note your selections, as these settings directly apply to ESX Upload functionality.
Figure 1: The Hypervisor Connection Wizard, standalone connection
- If you're configuring a Cluster Hypervisor Connection, you will be prompted in the Connection Setup Wizard to select a cluster, ESX host, and offload method. You'll also need to specify which SIRIS network interfaces to use. Please note your selections, as these settings directly apply to ESX Upload functionality. For example, if you set up the hypervisor connection for a vCenter cluster, the ESX upload will be sent to the ESX host chosen during the initial hypervisor connection configuration.
Figure 2: The Hypervisor Connection Wizard, cluster connection
1. In the Datto GUI:
- Click on the Restore tab to open restore options.
- Choose which agent to restore.
- Select ESX Upload as the recovery type.
- Pick which recovery point from which to restore, then click Start ESX upload.
Figure 3: Options in the Restore tab
2. From the Datastore drop-down menu, select the datastore you defined when you set up the hypervisor connection, then enter the upload's destination directory. You can give the upload directory a custom name here.
The device will alert you when the upload completes; you'll then be able to migrate the VM from local to a network datastore if desired.
Figure 4: ESX upload options
3.When the upload finishes, it will appear in the Restore tab as an active recovery. In the hypervisor, you can now either attach the .VMDK to an existing virtual machine template, or generate a new VM template and attach the .VMDK to the uploaded disk(s).
Figure 5: Configuring the VM in the hypervisor
4. Start the VM. Your recovery is complete.
Figure 6: The finished recovery