This article describes the procedure to synchronize a NAS RoundTrip drive to a Datto device. For background on the RoundTrip process, see the article RoundTrip Overview.
For details on synchronizing a USB RoundTrip with a Datto device, click here.
- Datto SIRIS
Connecting the NAS RoundTrip drive
1. Connect the power for the RoundTrip drive.
2. Connect the drive to the network:
To connect the RoundTrip NAS to your LAN, use the port on the NAS marked LAN. On this port, the NAS will attempt to obtain a DHCP address.
To connect the RoundTrip NAS directly to the Datto device, use the port on the NAS marked NIC-to-NIC, and connect it to the auxiliary NIC port marked eth1 on your Datto appliance.
The port on the NAS marked NIC-to-NIC communicates over a static IP address with your Datto appliance.
Datto recommends plugging into both the LAN and the Datto appliance, if possible. You will select which one to use later in this process.
Set up and run the RoundTrip
1.Log into the Datto device's web interface. Then, click on the Synchronize tab.
2. At the top of the page, click Start NAS RoundTrip, as shown in Figure 1.
3. Once the process has started, you will see a welcome screen. Click Next.
4. The next screen will display the available interfaces to sync the NAS RoundTrip. Here, you will see if the NAS has network connectivity or not. Once selected, click Next.
If you use the NIC-to-NIC method, you must use the port marked eth1 on both the Datto appliance and the RoundTrip drive.
5. Next, you will see all the NAS RoundTrip devices on the same network. Select the NAS RoundTrip, and click Next.
6. You will see the agents and NAS shares on the Datto device. Select the agents and shares that you wish to synchronize to the NAS RoundTrip. Max Space Needed shows the amount of space that each agent or share will use.
7. Once you've selected the agents and shares, you will see a final reminder, as well as confirmation that the NAS RoundTrip process is ready to begin.
Figure 7: Confirmation screen (click to enlarge)
Enter an email address to receive RoundTrip status updates. Datto recommends entering multiple addresses, to ensure receipt of notification if unreachable. Separate multiple email addresses with commas and no spaces. Then, click Start RoundTrip.
8. The page will refresh, and a progress bar and a status will populate with updated information, as shown in Figure 8.
Note: The initial process may take a few minutes.
As the process continues, you will see more details, as shown in Figure 9.
Once the synchronization finishes, you will see a confirmation. Local backups and offsite synchronization will automatically resume after the NAS RoundTrip has completed.
Immediately return the NAS RoundTrip to Datto to synchronize it with the Cloud. The return shipping label is in the box the RoundTrip drive came in. The PO # field will match the serial number of the Datto appliance for which the RoundTrip was ordered. If you misplace the label, check the RoundTrip policy (USA) or RoundTrip Policy (EMEA) for the shipping address.