This article describes how to view information about connected clients in a Datto Network using the Datto Networking App.
- Datto Networking App
The Datto Networking App provides a list of all active clients across all access points in a network. Additional statistics and metrics are also available for each individual client.
1. On the Networks page, scroll down to the network that houses the access points your clients are connected to, as seen in Figure 1.
2. Press View Network, or Clients.
3. Press the Clients tab, as seen in Figure 2.
Client & Usage Summary
The following information about all connected clients is available in this section:
A. Client Summary: Displays the total amount of clients on the network, and the number that are actively using data.
B. Usage Summary: Displays the total throughput of all clients, including download and upload.
Additional insight into individual information about clients is available through the app. Press on any client to display data about the health, statistics, and status of the client.
A. Last Seen: Displays when the client was last seen on the network.
A. RSSI (Received Signal Strength Indicator): This is used to measure how well the client's device can listen for the signal broadcast by the access point, and is displayed in dBm (decibel-milliwatts).
B. Usage: Displays the total amount of bandwidth utilized by the client, and then broken down into data downloaded, and uploaded respectively.
A. MAC Address: Displays the MAC address of the connected client's device.
B. Rate/Capabilities: Displays the wireless standard the client's device is using to connect to the access point, alongside potential maximum throughput.
C. Client Type: Displays the type of device the connected client is using.