Registering a Datto Networking device

Topic

This article describes the steps to register a Datto Networking device.

Environment

  • Datto Switches
  • Datto Routers
  • Datto Access Points
  • Datto Partner Portal

Description

This procedure does not apply to the Datto DNA. See Datto Networking Appliance (DNA): Getting started for DNA setup information.

Procedure

You need access to the Datto Partner Portal and Datto Network Manager to perform these steps.

1. In the Datto Partner Portal, click the Status tab, then select Networking Status from the drop-down menu.

mceclip0.png
Figure 1: The Datto Partner Portal

2. On the Networking Status page, click the Add Device button.

mceclip2.png
Figure 2: The Networking Status page

3. The Partner Portal will redirect you to the Datto Network Manager user interface. Click Manage in the left-hand navigation menu, then select the type of device you are adding.

mceclip5.png
Figure 3: The Datto Network Manager UI

4. Click the Add link for the type of device you are adding, then use the Additional Resources section below to find instructions for adding each device type.

mceclip0.png
Figure 4: The Add Switch link

Additional Resources