This article describes the Radio settings page in Datto Network Manager for Datto Access Points.
- Datto Access Points
- Datto Network Manager
All Datto Access Points share the radio settings in a network. Radio settings control available frequency bands, what channel the access point uses, and other global configurations.
In the Navigation menu, click Access Points, then select Radio from the expanded options.
The settings and options in the Radio page apply to all access points in a network. You can configure the following:
Select the appropriate country from the drop-down list.
The transmit power setting lets you configure the frequency bands used by all access points in your network. By default, this is set to Use country setting, which limits the maximum transmission power to the network's country as per its regulations. Use the drop-down to select a power in milliwatts (mW), which then broadcasts its maximum relative received signal strength (RSSI), or signal strength in decibels (dB). Consider reducing power in dense indoor networks with other high power devices.
Datto Networking offers two options for channel setting configuration: Auto and Manual.
When you select Auto, Datto Networking automatically configures channel settings daily for your network, taking into consideration mesh repeaters, nearby access points, and sources of interference. You can also manually set the Max channel width for each radio when using Auto; you cannot set the channel itself.
Channel settings update only during the network's maintenance window to avoid potential service disruptions. To force an update, click the Run optimization now button.
When selecting Manual, you set channels and maximum channel widths for all access points in a network. Datto Networking recommends not setting broad channel widths for environments with excessive interference.
Minimum Data Rates
Setting Minimum Data Rates can improve both roaming and overall WiFi network performance. This improvement involves disabling legacy client rates, which reduces overhead. For more information, read the Client Device Roaming article.
When you enable Internet check, the access points' SSIDs will broadcast only when there is an active internet connection. When you disable Internet check, they will continue broadcasting even when there is no internet connection. This feature lets local resources, such as printers and shared drives, continue to function.