Legacy Open Mesh: How do I disable the LEDs On My Open Mesh Access Point?



How do I disable the LED(s) on my Open Mesh Access Point?


  • Open Mesh Access Points


With firmware version 6.3 firmware and later, you can turn off the LEDs across all access points within a network.

You can find this toggle under Configure → Advanced Miscellaneous. The LEDs will be disabled one to two minutes after turning off this setting if your AP is online and actively checking in. This toggle will not be visible on firmware versions 6.2 firmware and earlier.

All models are supported, Models MR600 and OM5P-AC, however, cannot disable their ethernet LEDs (which should only apply if in a gateway position).

Was this article helpful?

0 out of 0 found this helpful

You must sign in before voting on this article.

Want to talk about it? Have a feature request?

Head on over to our Datto Community Forum or the Datto Community Online.

For more Business Management resources, see the Datto RMM Online Help and the Autotask PSA Online Help .

Still have questions? Get live help.

Datto Homepage