Legacy Open Mesh: Quality of Service (QoS)



This article describes how to configure and implement Quality of Service (QoS) using Open Mesh Switches.


  • Open Mesh Switches



Quality of service (QoS) allows operators to prioritize application traffic to ensure latency affected data, such as VoIP, and video conferencing is uninterrupted in a congested network. Open Mesh Switches implements this by reading tagged packets and prioritizing them accordingly. Packets are classified using Class of Service (CoS) on the data link layer, and Differentiated Services Code Points (DSCP) on the network layer, mapped to a queue, then sent out accordingly as per QoS.


1. Navigate to ManageSwitches, and select a switch.

2. Click Switch Settings.


Figure 1: Switch Settings

3. Click the Quality of Service (QoS) dropdown to reveal settings, and click the Enable checkbox to interact with them.

fig2.jpgFigure 2: Enabling QoS (click to enlarge)

4. Click Save Switch Settings to save all modified settings.

Configuring QoS

The following settings will allow you to choose what the switch will use for QoS, how traffic is weighted, and what queues are mapped:


Figure 3: QoS Settings

Trust Mode: Allows you to define whether the switch will use CoS, DSCP, or both trust modes for QoS.

Scheduling Method: Allows you to define what method the switch will use when assessing transmitting incoming packets in queues. Strict priority always prioritizes queues with a higher priority, while Weighted Round Robin (WRR) weights each queue by priority, then applies a round-robin policy when choosing packets for transmission.

Queue Mapping: Tagged packets are sent to queues defined in this setting. For each CoS or DSCP value, you can choose the queue to which these tagged packets should map.


Figure 4: CoS Queue Mappings


Figure 5: DSCP Queue Mappings

Port Specific Settings

If QoS is enabled in Switch Settings, you can configure additional settings per port. To navigate to these settings:

1. Click Port Settings.


Figure 6: Port Settings

2. Select the desired port, then click Configure.


Figure 7: Choosing a port 

3. Click the Quality of Service (QoS) dropdown to reveal settings.

fig8.jpgFigure 8: Enabling QoS (click to enlarge)

4. Click Save Switch Settings to save all modified settings.

The following CoS settings are available per port:


Figure 9: QoS port settings

CoS Value: All incoming packets that lack a CoS value will use the one set in this dropdown.

Trust CoS: If checked, the switch will queue packets tagged with CoS into their designated queues. If unchecked, all packets will leave the same queue.

Was this article helpful?

0 out of 0 found this helpful

You must sign in before voting on this article.

Want to talk about it? Have a feature request?

Head on over to our Datto Community Forum or the Datto Community Online.

For more Business Management resources, see the Datto RMM Online Help and the Autotask PSA Online Help .

Still have questions? Get live help.

Datto Homepage