To enhance the security of your account, Datto has launched a new caller entitlement process. For more information, see Partner Authentication for Support Phone Calls.

Legacy Open Mesh: What Do the LED Lights on the OM Series Mean?



What do the LED lights on the OM Series mean?


  • Datto Access Points


The LEDs (lights) on the OM Series access points let you know what the device is currently doing. This page contains an overview about the different color states and their meanings.

The OM Series has four lights. When looking at the device from the side with the ports, the lights are (left to right) power, Ethernet (x2) and WiFi.  

Figure 1: Datto OM Series LEDs (click to enlarge)

Ethernet 1 = eth1 interface ; Ethernet 2 = eth0 interface

The Power LED:

  • Blinks blue with the device is booting.
  • Displays solid blue after the boot has completed.

Ethernet LEDs:

  • Display solid blue as soon as a cable is plugged in to each port.
  • Blinks blue with traffic.


  • On gateways, the multi-color WiFi LED will show:
    • no color until DHCP address received
    • red solid if internet check fails but DHCP was received
    • green blink if internet works
  • On repeaters, the multi-color WiFi LED will show:
    • no color until speed test (dashboard checkin) has been run
    • red solid if speed to the gateway is below 1Mbps
    • yellow solid if speed to the gateway is above 1Mbps and below 2.5Mbps
    • green blink if speed to the gateway is above 2.5Mbps
    • red blink while the node is in lonely mode
    • yellow blink while the node is in orphan mode

Was this article helpful?

0 out of 0 found this helpful

You must sign in before voting on this article.

Want to talk about it? Have a feature request?

Head on over to our Datto Community Forum or the Datto Community Online.

For more Business Management resources, see the Datto RMM Online Help and the Autotask PSA Online Help .

Still have questions? Get live help.

Datto Homepage