Cloud Continuity for PCs: Bare Metal Restore: Getting started

Follow

Topic

This article describes the Cloud Continuity for PCs Bare Metal Restore (BMR) process. The Bare Metal Restore utility is a tool that performs a total reimage of target hardware.

Environment

  • Datto Utilities
  • Datto Cloud Continuity for PCs Bare Metal Restore

Description

Warnings

  • A Bare Metal Restore will cause the target device to perform a full backup when the restore finishes.
  • Due to the wide range of touchpad drivers, custom drivers, and hardware configurations available for both laptops and all-in-one workstations, restoration support for these platforms is 'best-effort' only.
  • Operating systems will be restored as a single partition.
  • Support of RAID hardware is dependent on compatibility with the Bare Metal Restore environment's kernel and version. See Ubuntu's list of certified compatible hardware for compatibility guidelines.
  • Bare Metal Restore does not support software RAID or FakeRAID (also known as 'HostRAID' or 'BiosRAID').
  • You cannot restore to a disk which is smaller than the disk image contained in the selected snapshot.

Prerequisites

General

  • Performing a Bare Metal Restore of a BitLocker-protected system will result in a non-encrypted restored machine. For more information, see our BitLocker Considerations article.
  • Touchscreens may not work after a Bare Metal Restore until you manually reinstall their drivers.

Requirements for the target hardware:

  • Datto recommends verifying that the target hardware is healthy, including checking the SMART values on hard drives to ensure healthy target disks.
  • The disk you are restoring to must be larger than the original disk. The disk does not have to be a specific size, as long it is larger.
  • Must be able to boot from USB.
  • Internet access is required for the BMR. 
  • Must be 64-bit hardware.
  • The hardware must be able to support the system image you are restoring to it fully.

You should have the following items available when starting this process:

  • USB stick that is at least 8 GB.
  • We will automatically detect storage controllers and inject them as needed. You may still want to collect any other drivers to apply after the imaging is complete.

Process

Overview

  • The BMR process will auto-partition the desired machine to the same configuration used by the original hardware.
  • The BMR process will then auto-image the target hardware from the cloud snapshot you select.

Procedure

  1. Image a USB stick with the latest version of the Datto Utilities Image. For more information about this process, see Imaging a USB Drive with Datto Utilities
  2. Once the imaging process completes successfully, unplug the USB stick, and proceed to the article Datto Utilities: Booting the target machine from USB.

Was this article helpful?

0 out of 0 found this helpful

You must sign in before voting on this article.

Want to talk about it? Have a feature request?

Head on over to our Datto Community Forum or the Datto Community Online.

For more Business Management resources, see the Datto RMM Online Help and the Autotask PSA Online Help .

Still have questions? Get live help.

Datto Homepage